Industry News
-
Why does a double pilot-check valve fail to hold load (drift) and how to fix it
- A double pilot-check valve is designed to lock a hydraulic load in place, but over time you may notice slow movement or “drift.” This usually points to internal leakage or control issues that reduce the valve’s ability to seal under pressure. Below are the most common causes and practical fixes.
- MORE DETAILS
2026-03-11
-
What Causes Internal Leakage in a Directional Control Valve and How to Test for It
- Internal leakage in a directional control valve reduces system efficiency, causes slow or weak actuator movement, and leads to unstable pressure control. Because the leak happens inside the valve body, it often goes unnoticed until performance drops.
- MORE DETAILS
2026-03-04
-
How to Fix a Directional Valve Stuck in One Position
- A directional valve stuck in one position can halt an entire hydraulic or pneumatic system. This issue is often caused by contamination, mechanical binding, or control problems. A systematic approach helps restore normal operation quickly and safely.
- MORE DETAILS
2026-02-25
-
How to Troubleshoot Electrical Noise Interfering with Proportional Valve Control Signals
- Electrical noise can disrupt proportional valve control signals, leading to unstable motion, drifting, or inconsistent response. Because these valves rely on precise electrical input, even small interference can cause noticeable performance issues. A structured troubleshooting approach helps pinpoint and eliminate the source.
- MORE DETAILS
2026-02-11
-
Why Does My Proportional Valve Drift or Fail to Hold Position Accurately
- Proportional valves are designed for precise flow or pressure control, so drifting or poor position holding can seriously affect system performance. These issues are usually caused by a mix of mechanical wear, contamination, and control signal problems.
- MORE DETAILS
2026-01-13
English
Español
русский
français
Deutsch
